Filter
Top Products
24 PR-Series Operator’s Manual-E/F
Operating the Washer
PIC93-102299R0
A
B
C
Honda
Subaru
PIC93R-121902R0
B
A
C
SHUTDOWN
IMPORTANT: Shutdown procedures should be followed
at the end of each cleaning operation.
1. If a detergent was used, place detergent inlet strainer
in CLEAN water and operate trigger to spray water for
a period of three minutes. This will ush the system of
detergents and help prevent the detergent valve from
sticking or corrosion.
2. Run engine at idle for 2-3 minutes.
3. Turn engine of by:
a. Moving throttle lever (A) fully to the right.
b. Turn engine switch (B) to “OFF” position.
c. Move fuel valve (C) left to “OFF” position.
4. Turn inlet water supply off. Squeeze trigger momentarily
to relieve pressure. Disconnect hoses.
5. Allow engine to cool, then wipe washer down with a
damp cloth.