Filter
Top Products
PR-Series Operator’s Manual-E/F 19
Operating the Washer
LOCKING GUN TRIGGER
CAUTION: Gun trigger should be locked when not
in use or whenever adjustments are being made
to gun or nozzle. This will help prevent accidental
discharge of high pressure uid.
1. Pivot lock (A) out to prevent trigger engagement.
2. Pivot lock in to release trigger.
PIC73-102299R1
A
WATER PRESSURE
Water pressure is preset on washers and should only be
serviced by an authorized dealer.
P07-013107
PIC81-102299R0
CHANGING NOZZLE
CAUTION: High pressure spray can cause serious
injury. Keep away from spray. Never point the gun
at yourself or anyone else. Never put your hand,
ngers, eyes or body directly over spray. Do not
point spray toward fragile materials.
CAUTION: To avoid injury from escaping uids
under pressure, relieve the pressure in the system
by stopping the washer and depressing gun
trigger. Lock trigger before changing or adjusting
nozzle.
Be sure nozzle is tightly attached before operating
to help prevent nozzle release.
1. Retract locking ring (A) of quick-connect tting and
remove nozzle (B).
2. Insert nozzle and push ring forward and lock nozzle in
place. Be sure nozzle is fastened to wand.
SELECTING THE PROPER NOZZLE
Pressure and volume are partially determined by the size
of the orice in the nozzle. Standard numbers are on the
nozzles to indicate spray pattern and orice size. For
example, a nozzle stamped 2503 has a 25° spray pattern
and a 3.0 orice.
B
A