Filter
Top Products
18 PR-Series Operator’s Manual-E/F
STARTING AND OPERATING ENGINE
CAUTION: Do not run engine in an enclosed area.
Exhaust gas contains carbon monoxide, an odorless and
poisonous gas that can cause sickness or death.
IMPORTANT: To prevent possible pump damage, do not allow
washer pump to run in bypass (with gun trigger
released) for longer than 3 minutes.
IMPORTANT: During rst two hours of engine operation, engine
may operate at low or erratic RPM as the engine
moving parts break in.
1. Set fuel valve lever (A) right to ON position.
2. Move choke control lever (C) left to “CHOKE” position.
NOTE: A warm engine requires less choking than a cold
engine.
3. Move throttle lever (B) left to the fast position.
NOTE: For best engine performance it is recommended the engine
be operated with the throttle in the FAST position.
4. Turn the engine switch (D) to “ON” to position.
5. Place foot on washer frame.
6. Point nozzle away from people, animals or fragile materials
and squeeze gun trigger.
CAUTION: Be sure nozzle output end is not directed at
bystander or objects. Pressurized output spray will start
almost instantaneously at engine start-up and can cause
serious personal injury or property damage. Release
trigger immediately upon engine start.
7. Pull recoil starter grip lightly until resistance is felt, then pull
briskly until engine starts.
IMPORTANT: Do not allow starter grip to snap back against
engine. Return it gently to prevent damage to
starter.
8. Move “CHOKE” control lever (B) right to open position as soon
as engine warms up enough to run smoothly. If engine is warm,
move choke lever right as soon as engine starts.
STOPPING THE ENGINE
IMPORTANT: To stop engine in emergency, turn engine switch
(D) down to “OFF” position.
1. Move throttle lever (C) fully to the right.
2. Turn engine switch (D) to “OFF” position.
3. Move fuel valve (A) left to “OFF” position.
4. Trigger gun to relieve spray.
Operating the Washer
PIC66R•121902R0
C
D
A
B
DWG14-102299R0
PIC66•102299R0
D
C
A
B
Honda
Subaru