Filter
Top Products
ENGLISH
Drain Information
A drain/overflow assembly (sold separately) must be
installed on the bath, water tested, and connected to
the sanitary system of the house. After opening the
carton, inspect for damage and verify that the kit is of
the proper finish. In the Jacuzzi Whirlpool Bath drain/
overflow kit, note that the waste flange, strainer, over-
flow cover and cover screws are packaged in a sepa-
rate package within the kit to protect the trim finish.
Follow the installation instructions provided with the
drain/overflow kit. After the drain is fully installed, test
for proper drainage. If the unit does not drain properly,
rectify this condition before proceeding with the instal-
lation. Jacuzzi Whirlpool Bath is not responsible for
removal and or reinstallation costs.
NOTE: Watertight installation of the drain is the in-
staller's responsibility. Drain leakage is excluded
from the Jacuzzi Whirlpool Bath warranty of this
product.
Plumbing
Pump, jets, and suction fittings for the whirlpool sys-
tem are factory plumbed in schedule 40 PVC piping.
All Jacuzzi Whirlpool Bath products are factory tested
for proper operation and watertight connections prior to
shipping. If leaks are detected, notify your Jacuzzi Whirl-
pool Bath Dealer. Do not install the unit.
Water Supply
Consult local authorities for plumbing code require-
ments in your area.
IMPORTANT: Proper installation of the fill spout
plumbing and compliance with local codes are the
responsibility of the installer. Jacuzzi Whirlpool Bath
does not warrant connections of water supply fit-
tings and piping, fill systems, or drain/overflow sys-
tems. Nor is it responsible for damage to the bath
which occurs during installation.
CAUTION: A nonflammable protective barrier must
be placed between soldering work and bath unit to
prevent damage to the bath.
Clean-Up After Installation
To avoid dulling and scratching the surface of the bath,
never use abrasive cleaners. A mild liquid detergent
and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge.
Metal tools will scratch the surface. Spots left by plas-
ter or grout can be removed if lightly rubbed with deter-
gent on a damp cloth or sponge.
Paint, tar, or other difficult stains can be removed with
paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol).
Minor scratches which do not penetrate the color fin-
ish can be removed by lightly sanding with 600-grit wet/
dry sandpaper. You can restore the glossy finish to the
acrylic surface of the bath with a special compound,
Meguiar's #10 Mirror Glaze. If that is not available, use
automotive rubbing compound followed by an applica-
tion of automotive paste wax.
Major scratches and gouges which penetrate the
acrylic surface will require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer for special instructions.
INSTALLATION
8
Jacuzzi Whirlpool Bath© U961000G 2/05