Filter
Top Products
9
Service Access
Service access is through the removable panel. To
remove panel, grab the middle of the panel and bow
outwards till clips disengage.
SERVICE ACCESS PANEL
GRAB PANEL IN MIDDLE
AND BOW OUTWARDS
BOW ACCESS
PANEL OUTWARD
FROM CENTER
SHELL
ACCESS
PANEL
To reinstall the panel hold at an angle to the skirt and
insert clip under edge of skirt opening. Bow the panel
outward and insert clip on other side.
Note: The combined thickness of the tile (or other
finish material), adhesive and cement board must not
exceed the edge of the vertical wall on the drain side.
This condition will not allow the wall jamb of the steam
enclosure to sit flat against the vertical wall.
TILE FLUSH WITH
VERTICAL WALL
FINISH SURFACE
DRAIN
Clean-Up After Installation
To avoid dulling and scratching the surface of the
shower base, never use abrasive cleaners. A mild liquid
detergent and warm water will clean soiled surfaces.
Remove spilled plaster with a wood or plastic edge.
Metal tools will scratch the surface. Spots left by plaster
or grout can be removed if lightly rubbed with detergent
on a damp cloth or sponge.
Paint, tar, or other difficult stains can be removed with
paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol).
Minor scratches which do not penetrate the color
finish can be removed by lightly sanding with 600-grit
wet/dry sandpaper. You can restore the glossy finish to
the acrylic surface of the shower base with a special
compound, Meguiar's #10 Mirror Glaze. If that is not
available, use automotive rubbing compound followed
by an application of automotive paste wax.
Major scratches and gouges which penetrate the
acrylic surface will require refinishing. Ask your Jacuzzi
Whirlpool Bath dealer for special instructions.
TILE NOT FLUSH WITH
VERTICAL WALL
FINISH SURFACE
DRAIN
3/16"
MAXIMUM
GAP
VERTICAL WALL
If there is a gap between the finish surface and the
vertical wall, a filler piece (included with steam enclo-
sure) may be required. Gap must not exceed 3/16".
Silicone sealant will also be necessary to eliminate any
additional gaps that may be present.