Attention New Spa Owner!
Congratulations on the purchase of your new Jacuzzi Premium spa! The
following is a list of automated functions performed by your spa. These
functions are listed below in an attempt to suppress any operational con-
cerns you may have during the first 24-hours of ownership! Also listed
below are important maintenance recommendations you should observe
on a regular basis to protect your new investment.
Automated Operations
Your new spa is equipped with an automated “blow-out” cycle that clears
all plumbing lines daily to promote maximum water sanitation. Each day
at 12:00 PM (noon), pump 2 (and J-380 pump 3) will automatically turn
on for a period of one minute, then go off. Then pump 1 will turn on
and run for one minute to complete the cycle. Be a
ware, the factory
programmed blow-out cycle cannot be canceled or altered! However, If
you set one of four programmable skimming/heating cycles to overlap or
start at 12:00 (noon), pump 1 will turn on as programmed and operate
for the duration of the programmed cycle, overriding the factory “blow-
out” cycle. See page 30 for detailed skimming/heating cycle program-
ming instructions.
Filter Maintenance
Your new spa is equipped with an advanced 2-stage water filtration
system that provides unsurpassed water quality! To ensure maximum
water quality at all times, you should clean and reuse the skimmer bag
and both filter cartridges once a month. See page 33-34 for detailed
cleaning instructions.
Water Maintenance
You will want to replace the spa’s water every 3 to 6 months. The
frequency depends on a number of variables including the frequency of
use, number of users, attention paid to water quality maintenance, etc.
You will know it is time for a change when you cannot control sudsing
and/or you can no longer get the normal feel or sparkle to the water,
even though the key water balance measurements are all within the
proper parameters. See page 39 for additional information.