Filter
Top Products
33
J-300
11.6 Programming the CLEARRAY Bulb Replacement Timer
To make changes to the CLEARRAY bulb replacement timer or to reset
it, follow the steps below (Figure 7).
A. Press the Menu (
) button three times to display the CLEARRAY
Bulb Replacement Timer Menu. The LED screen will display “U.”
B. Press the Warmer ( ) button to enter the menu. The LED screen
will display the number of days remaining or zero.
Note: If you press the Warmer ( ) button after the number of days
remaining you will revert back to the “U” menu. You will need to repeat
step B to re-enter the menu.
C. Press the Jets Pump 1 ( ) button to access the CLEARRAY bulb
replacement timer. The display on the LED screen will blink once to
indicate that the system is ready to accept changes.
D. Pressing the Warmer ( ) or Cooler ( ) button will add or
subtract days in increments of 10 days except when 360 is reached.
Then a 5-day increment occurs. The range for programming is from 0
to 365 days.
E. Once you select the number of days, press the Jets Pump 1 (
)
button to conrm the selection. The display of the LED screen will
blink twice to indicate that the changes have been accepted. You
must press the Jets Pump 1 ( ) button to conrm your selection
or the current settings will remain active.
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
11.7 Economy Menu
In Economy mode, the heater only activates after a Secondary Filtration
cycle has nished. The heater will run for a maximum of 30 minutes.
The heater can turn off prior to the 30 minutes if the programmed
water temperature is reached. The Secondary Filtration program
determines the number of cycles (from 1 to 4) that the heater will be
allowed to activate. For example, if you have programmed the SF3
setting (10 minutes of ltration every 6 hours), then the heater will run,
for a maximum of 30 minutes, after the end of each of the 10-minute
secondary ltration cycle, for up to four times per day. Reference the
chart that follows.
Will return to
the “U” menu
Blinks once
Blinks twice
Activates
submenu for
changes
Adds days in
10-day incre-
ments
OR
OR
Substracts days
in 10-day incre-
ments
PRESS
PRESS
PRESS
PRESS
Figure 7