Filter
Top Products
ENGLISH
Drain Information
A drain/overflow assembly (sold separately) must be installed on the bath, water tested, and connected to the sanitary system of the house.
After opening the carton, inspect for damage and verify that the kit is of the proper finish. In the Jacuzzi Whirlpool Bath
©
drain/overflow kit, note
that the waste flange, strainer, overflow cover and cover screws are packaged in a separate package within the kit to protect the trim finish.
Follow the installation instructions provided with your drain/overflow kit. After the drain is fully installed, test for proper drainage. If the unit does
not drain properly, rectify this condition before proceeding with the installation. Jacuzzi Whirlpool Bath
©
is not responsible for removal and or
reinstallation costs.
NOTE: Watertight installation of the drain is the installer's responsibility. Drain leakage is excluded from the Jacuzzi Whirlpool
Bath
©
warranty of this product.
Plumbing
Pump, jets, and suction fittings for the whirlpool system are factory plumbed in Schedule 40 PVC piping.
All Jacuzzi Whirlpool Bath
©
products are factory tested for proper operation and watertight connections prior to shipping. If leaks are
detected, notify Jacuzzi Whirlpool Bath. Do not install the unit.
Water Supply
Consult local authorities for plumbing code requirements in your area.
IMPORTANT: Proper installation of the fill spout plumbing and compliance with local codes are the responsibility of the installer.
Jacuzzi Whirlpool Bath
©
does not warrant connections of water supply fittings and piping, fill systems, or drain/overflow systems.
Nor is it responsible for damage to the bath which occurs during installation.
CAUTION: A nonflammable protective barrier must be placed between soldering work and bath unit to prevent damage to the bath.
Clean-Up After Installation
To avoid dulling and scratching the surface of the bath, never use abrasive cleaners. A mild liquid detergent and warm water will clean
soiled surfaces.
Remove spilled plaster with a wood or plastic edge. Metal tools will scratch the surface. Spots left by plaster or grout can be removed if
lightly rubbed with detergent on a damp cloth or sponge.
Major scratches and gouges which penetrate the acrylic surface will require refinishing. Contact your Jacuzzi Whirlpool Bath
©
dealer for
special instructions.
Plumbing and Water Supply
8
Jacuzzi Whirlpool Bath
©
BP43000 2/05