Filter
Top Products
10-32 109706 10/08
To adjust the stops for driving straight when control levers are against the stops during operation:
1. Determine which drive tire is rotating too fast when both control levers are against the
stops. Then stop the tractor and loosen the lock nut on the side which is rotating too
fast and turn the stop (set screw) inward to stop the control lever sooner. Tighten the
lock nut on the stop and test again. Repeat this procedure until unit drives straight.
NOTE: Since this is a hydrostatic drive, variables such as temperature of oil,
efficiency of pumps and motors, tire pressure etc. may effect the con-
sistency of the ability to rely on the stops to drive straight without the
operator making minor steering adjustments with the control arms.
Steering dampener
The steering dampener (FIG. 54) is spring loaded to return the control levers to the neutral position from the reverse
position. This gives the operator a sense of neutral during operation.
To set the steering dampeners in the correct operating position follow these steps:
1. Place the control lever in the neutral position.
2. Loosen the steering dampener’s front ball stud.
3. Pull the dampener spring housing past the point that the internal spring is engaged.
4. Release the dampener spring housing and allow the internal spring to bring the housing
back to the neutral position.
5. Tighten the nut on the steering dampener’s front ball stud.
FIG. 54 FIG. 55
SPRING HOUSING
FRONT BALL
STUD
CAP SCREWS
LOWER CONTROL
LEVER
UPPER CONTROL
LEVER