Filter
Top Products
10-20 109706 10/08
1. Smear a light coating of oil on filter’s o-rings.
2. Insert the filter element into the hydraulic reservoir housing. Tighten the oil filter 10 ft.-
lbs. (13.56 Nm) — DO NOT OVERTIGHTEN.
3. Start tractor engine and let run at approximately 2/3 throttle for a few minutes to work
any trapped air out of the system before engaging the steering control lever.
4. Stop the engine and check the filter and connections for leaks.
5. Check the hydraulic reservoir for specified oil level. Add clean oil as necessary.
Clean or replace hydraulic reservoir cap annually. Cap may be cleaned by dipping in or flushing with cleaning sol-
vent. Follow manufacturer’s instructions and warnings for application of solvent type selected.
FIG. 30
HYDRAULIC RESERVOIR
HYDRAULIC FILTER