Husqvarna 4421-G/GX/GXL Utility Vehicle User Manual


 
Brake Fluid Reservoir
BRAKE FLUID RESERVOIR
1
2
1
2
3
1. Full Level 2. Safe Level 3. Low Level
201
Figure
17 Brake Fluid and Coolant Access (diesel vehicle
shown)
202
Figure 18 Brake Fluid Reservoir
The brake uid reservoir (1) is located under the hood (Figure 17). Raise the hood to check the brake uid level.
During the brake uid level inspection, also inspect the following:
The presence of brake uid on the exterior surface of the master cylinder indicates a leak.
The brake uid reservoir diaphragm (located in the cap) should not have holes or other damage.
BRAKE FLUID
Brake uid level should be within 1/4-inch (6 mm) from the top of the reservoir (Figure 18). Also, brake uid should be
clean with no residue in the bottom of the reservoir or other evidence of contamination.
CAUTION
Use only DOT 5 (silicone) brake uid. Use of any other type brake uid is not recommended.
Page 38 HUV 4421 Owner’s Manual