Husqvarna 4421-G/GX/GXL Utility Vehicle User Manual


 
Driving Instructions
7. Press and hold the brake pedal.
8. To start the vehicle
8.1. Gasoline vehicles: Turn the key to the START position and hold it there until the engine starts. Activate
the choke as necessary. If the engine does not start after 10-15 seconds, release the key and repeat the
procedure. Once the engine starts, release the key and it will return to the ON position. The engine
will idle in neutral.
8.2. Diesel vehicles: To preheat glow plugs in cold weather, turn the key to the PREHEAT position and hold it
there for 10-15 seconds. Turn the key to the START position and hold it there until the engine starts. If the
engine does not start after 10-15 seconds, turn the key to the OFF position and repeat the procedure. Once
the engine starts, release the key and it will return to the ON position. The engine will idle in neutral.
9. Release the park brake.
10. Keep the brake pedal engaged, and select direction of travel by placing the shift handle in the desired position
(Figure 6 or Figure 7). The engine must be at idle before the shift handle is moved. If equipped with a reverse
buzzer, the reverse buzzer will sound as a warning when the Forward/Reverse handle is in the REVERSE position.
11. Release the brake pedal completely, and then slowly press the accelerator pedal. As the accelerator pedal is
pressed, the vehicle will begin to move. Vehicle speed will increase as the accelerator is pressed until full speed is
reached. All-wheel drive will automatically drive the appropriate wheel(s) as required. See following WARNING.
WARNING
Operator must control vehicle speed when going downhill.
Never shift the vehicle out of the FORWARD position while going downhill. If you do, you will not be
able to shift into the REVERSE position or back into the FORWARD position until stopped.
Press the brake pedal as necessary and press the accelerator pedal partially when descending a hill.
With the accelerator pedal partially pressed, the governor will cause the engine to assist the brakes in
controlling downhill speed.
ALL-WHEEL DRIVE (AWD) OPERATION
All HUV 4421 gas and diesel vehicles feature an all-wheel drive (AWD) system. The AWD system automatically directs
power to the wheel, or wheels, that have the most traction, providing optimum traction at all times. For example, if all
wheels except the rear passenger-side wheel lose traction, then power will be directed to the rear passenger-side
wheel. The all-wheel drive vehicle can adapt traction for a wide variety of driving surfaces and conditions. See
following WARNING.
WARNING
When servicing the vehicle with part of the vehicle on jack stands, do not operate the engine with the
Forward/Reverse handle in either the FORWARD or REVERSE position. The all-wheel drive system will
engage any wheel(s), front or rear, with traction (Figure 3).
The diameter of all tires on the vehicle must be equal, otherwise the all-wheel drive system will not
operate as intended and could result in severe personal injury or death. Never install tires of different
diameters on the vehicle.
Under most circumstances the driver will not need to do anything to engage the AWD system; however, the front
differential may become locked (rotate at the same speed regardless of the terrain) under certain conditions. If the
front differential becomes locked, drive slowly in reverse for at least 10 feet (3 meters), then brake gently. See
following WARNING.
HUV 4421 Owner’s Manual Page 25