Filter
Top Products
Seat Latch and Adjustment
WARNING
• Do not operate the vehicle with the ROPS removed. Doing so could result in property damage,
personal injury, or death.
• Do not remove or modify any component of the ROPS structure. Doing so will result in voiding the
ROPS certication and could weaken the ROPS, resulting in serious injury or death.
• Do not operate the vehicle if the ROPS is damaged. If the ROPS is damaged, replace the structure.
Do not attempt repair.
• The driver and passenger must be restrained at all times with the seat belts provided to help prevent
injury in the event of sudden braking, collision, or roll-over.
• In the event of a roll-over, do not attempt to jump or otherwise exit the vehicle. Remain seated with
safety belt fastened and with arms and legs inside the vehicle.
• After inserting the tab, make sure the tab and buckle are locked and that the belt is not twisted.
• Loose tting seat belts could increase the chance of injury due to sliding under the belt if sudden
braking should occur. Keep the safety belt snug and positioned as low on the hip bone as possible.
• Use a single safety belt for one person at a time. Do not use a single safety belt for two or more
people – this includes children.
• No more than one person per bucket seat at one time. No more than two persons per bench seat at
one time. Do not allow people to ride in any part of the vehicle that is not equipped with a seat and a
safety belt. Do not allow a passenger to hold a child in his or her lap while the vehicle is moving.
• This vehicle is not designed to meet child seat compatibility requirements. Children requiring a child
safety seat must not ride on the vehicle. Comply with state and local laws pertaining to child safety.
CAUTION
• Be careful not to damage the safety belt webbing or hardware.
• Inspect the safety belt system periodically. Check for cuts, fraying, and loose parts. Damaged parts
should be replaced immediately. Do not disassemble or modify the system.
• Keep seat belts clean and dry. If cleaning is necessary, use a mild soap and lukewarm water solution.
Do not use bleach, dye or abrasive cleaners as they may severely weaken the seat belts.
• Do not insert coins, clip, etc. in the buckle as this may prevent the tab from locking into the buckle
properly.
• If the safety belt does not function normally, contact your dealer/distributor or trained technician
immediately. Do not occupy the seat until the safety belt is repaired.
SEAT LATCH AND ADJUSTMENT
The vehicle seat(s) are hinged to allow easy access to the engine compartment. To raise the seat bottom, grasp the
rear side of the seat bottom, and pull rmly in a forward/upward direction. See following WARNING.
WARNING
• Make sure seat hinges and latches are securely engaged before operating the vehicle.
Vehicles with bucket seat option:
The driver-side bucket seat is adjustable and can be moved forward or backward to accommodate the driver. To adjust
this seat, push the lever located under the driver seat to the left (towards outside of the vehicle). Position the seat, and
return the lever to its original position. See following WARNING.
HUV 4421 Owner’s Manual Page 21