Roll-Over Protective Structure and Seat Belts
normal safe operating temperature, the warning light will illuminate. If the warning light lights up, stop the vehicle and
allow it to idle for approximately ve minutes before stopping the engine. Contact the dealer/distributor or a trained
technician. See following WARNING.
WARNING
• Allow the engine to cool before servicing the engine coolant system. Engine coolant can cause
severe burns.
ROLL-OVER PROTECTIVE STRUCTURE AND SEAT BELTS
HUV 4421 two passenger and four passenger vehicles are equipped with a Roll-Over Protective Structure (ROPS) and
seat belts for each occupant. See following WARNING.
WARNING
• The ROPS must be properly installed before operating the vehicle. Husqvarna strongly urges that the
vehicle’s occupants be properly restrained at all times with the seat belts provided.
Pregnant woman: Consult your doctor for specic recommendations. The safety belt should be worn securely and
as low as possible over the hips and not on the waist.
Injured person: Depending on the injury, rst check with your doctor for specic recommendations.
To secure the safety belt, sit up straight and well back in the seat. Pull the safety belt out of the retractor and insert the
tab into the buckle. A click will be heard when the tab locks into the buckle. Position the lap belt as low as possible
on the hips – not on the waist.
The retractor will lock the belt during a sudden stop. It also may lock if the occupant leans forward too quickly. A slow,
easy motion will allow the belt to extend, and the occupant can move freely. If the safety belt cannot be pulled out of
the retractor, rmly pull the belt and release it. It should then pull smoothly out of the retractor.
To release the safety belt, press the buckle release button (1) and allow the belt to retract (Figure 9). If the belt does
not retract smoothly, pull it out and check for kinks or twists. Then make sure it remains free of twists as it retracts.
1
194
Figure 9 Release Safety Belt
Page 20 HUV 4421 Owner’s Manual