General Warnings
DISCONNECTING THE BATTERY – GASOLINE/DIESEL VEHICLES
1. Disable the vehicle. See Disabling the Vehicle on page 12.
2. Disconnect the battery cables, negative (–) cable rst, as shown (Figure 2).
3. Gasoline Vehicles Only: Disconnect the spark plug wire(s) from the spark plug(s).
NEG
POS
1
2
(–)
(+)
1. Remove negative battery cable.
2. Remove positive battery cable.
Connect battery cables in reverse order.
188
Figure 2 Battery Cable Removal
189
Figure 3 All-Wheel Drive Warning
CONNECTING THE BATTERY – GASOLINE/DIESEL VEHICLES
1. Connect the battery cables, positive (+) cable rst.
2. Tighten battery terminals to 80 in-lb (9 N·m).
3. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305) to minimize corrosion.
4. Gasoline Vehicles Only: Connect the spark plug wire(s) to the spark plug(s).
RECYCLING LEAD-ACID BATTERIES
WARNING
• Lead-acid batteries contain lead (Pb), other metals, acids and other compounds. If improperly handled,
they can contaminate both water and soil, causing environmental damage and personal injury.
Lead-acid batteries are identied by the symbol shown below and should be properly recycled (Figure 4). They cannot
be disposed as municipal waste and must be collected separately. Responsibility for environmental protection must be
shared, not only by the manufacturers of the batteries, but by people who use the batteries as well. Please contact
your nearest Husqvarna dealer or distributor for information on how to properly recycle your batteries.
HUV 4421 Owner’s Manual Page 13