Filter
Top Products
34 – English
Repair instructions
Push the rear carburettor mounting into its rubber
bushing using a small screwdriver. Remove stop
plate 502 54 17-01.
4
5
Connect the leads to the stop switch.
Fit the carburettor. Screw in the carburettor bolts
directly from behind, without lifting the carburettor
assembly. Tighten to a torque of 1–1.5 Nm. It is
important to hold the carburettor flange while
tightening the bolts to prevent the inlet manifold
from moving.
3
2
Connect the fuel hose to the carburettor. Refit the
throttle pushrod at the same time as the rubber
inlet manifold, press in the throttle pushrod so that
it engages in the carburettor and fit the spring.
Carburettor heater 346XP, 351, 353 –
Refitting
Heating element
1
Fit the heating element between the air filter
connection and the carburettor as well as above
the carburettor.
2
Tighten the bracket above the carburettor using the
two bolts.
3
Connect the leads to the carburettor heater.
Refit:
• carburettor