Filter
Top Products
24 – English
Repair instructions
Generator – refitting
1
Feed the generator lead through the holes in the
crankcase and hand grip. Bolt the generator in
position, tightening the bolts to a torque of 5 Nm.
Clip the lead to the tank.
NOTE! The lead connector must be positioned on
the right of the clip, see diagram. Connect the lead
to the connector on the hand grip.
2
Refit:
• fuel tank with both stops and rear vibration
damping spring
• fuel hose to carburettor, hose length between
tank and crankcase: 43 mm/1.69 inches and
between crankcase and carburettor: 53 mm/2.09
inches
• throttle pushrod to carburettor
• flywheel with nut and washer
• cable guide, leads and starter assembly
Remove the piston stop and reconnect the HT lead
and cylinder cover.
4
Remove the fuel hose and throttle pushrod from
the carburettor.
Unbolt the rear tank mounting from the crankcase,
i.e. the rear vibration damping spring, and both
stops. Lower the tank as far as it will go to allow
access to the heater lead where it is connected to
the tank.
5
Disconnect the generator lead from the hand grip
and unclip it from the tank. Remove the generator
and lead.
Replacing the generator, model 346XP,
351, 353
1
Remove the cylinder cover. Disconnect the HT lead,
remove the spark plug and fit piston stop 502 54 15-
01 in its place. Take off the starter assembly, release
the leads from the cable guide and remove it.
Remove the cover from the hand grip.
2
Loosen the flywheel nut using a suitable socket
and unscrew it until it is flush with the end of the
shaft.
Position puller 504 90 90-02 over the magnets and
counterweight on the flywheel. Tighten 2–3 turns
and tap the head of the puller with a metal mallet to
release the flywheel. Remove the puller, nut and
washer. Lift off the flywheel.
3
Unscrew the two bolts from the generator but leave
the generator in place.