Filter
Top Products
English – 25
Repair instructions
3
Then refit:
• cable guide and press the leads into position
• HT lead
• starter assembly, tighten to a torque of 2.5–3.5
Nm
• cylinder cover
Ignition module and flywheel – refitting
1
Place the flywheel on the crankshaft. Turn the
flywheel so that the key lines up with the keyway in
the shaft.
Fit the washer and nut on the shaft and tighten to a
torque of 25-30 Nm.
2
To refit the ignition module proceed as follows:
Turn the flywheel so that the magnets are in line
with the ignition module. Fit the ignition module
with the plastic feeler gauge (502 51 34-01) held in
position at the same time, without tightening the
bolts. Connect the black earth lead to the front
screw on the ignition module. Adjust the gap
between the ignition module and magnet to 0.3 +/-
0.1 mm. The gap must be measured at either of
the two lowest pegs on the ignition module.
Tighten the bolts to 4.5–6 Nm. Connect the blue
lead to the ignition module.
0,3 mm