Filter
Top Products
28
SET PUMP
OPERATION
PUMP
PUMP
SYSTEM OFF
There are four advanced features available to customize the ICC to more
complex watering requirements. Two of these features are “hidden” to
make accidentally programming them nearly impossible.
1. Set Pump/Master Valve Operation
The default is for all stations to have the master valve/pump start circuit
ON. The master valve/pump start can be set ON or OFF by station,
regardless of which program the station is assigned. This feature may
be utilized on systems where it is desirable for a booster pump not to
operate with certain zones.
To program pump operation:
1. Turn the dial to SET PUMP
OPERATION position.
2. Press the or buttons to
toggle the Master valve/pump
start ON or OFF for the
specific station.
3. Press the button to
advance to the next station.
4. Repeat steps 2 and 3 for all
necessary stations.
2. Programmable Rain Off
This feature permits the user to
stop all programmed waterings for
a designated period from 1 to 7
days. At the end of the Rain Delay,
the controller will resume normal
automatic operation.
1. Turn the dial to the SYSTEM
OFF position.
2. Press the button and a 1
will be displayed and the DAYS
icon will illuminate. The 1 will
be blinking at this point.
3. Press as many times as needed to set the number of days off
desired (up to 7).
4. To validate this setting (and to make sure the controller comes back
on after the period is over), turn the dial back to the RUN position at
which time, OFF, a number and the DAYS icon all remain on.
5. Leave the dial in the RUN position.
NOTE: The days off remaining will decrease at
midnight of each day. When it goes to zero, the
display will show the normal time of day and
normal irrigation will resume at the next scheduled
start time.
ADVANCED FEATURES ...........................................................................................................