Filter
Top Products
Page 15
August 20, 2008
BODEGA BAY WOOD INSERT
R
435-1320B
ZERO CLEARANCE ADJUSTABLE TRIM SUPPORT, 2” to 10”
Part No. 841-0990, size 9”d x 45”w and Part No. ADJSPT-12, size 12”d x 50”w
Included in Kit: (1) Trim Top, (1) Trim Front, (2) Trim Sides, Double-Sided Tape (already installed)
Tools Needed: Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. See Figure 15A.
2. Expand scissors to desired height. Tighten screws to
hold in place using Phillips Head screwdriver. See
Figure 15B.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trim’s edge, not bottom. This edge will be
sharp; wear gloves to prevent injury to your hands. See
Figure 15B.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge ts under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a particularly powerful bonding adhe-
sive. Adjustments are extremely difcult once trim has
adhered to tape. Do a dry run rst without removing
paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on rst and then front piece.
The front piece overlaps side pieces. NOTE: The trim in
the Flush Mount Kit is one piece.
7. Once you are satised with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
NOTE:
3/8” ( 9.5mm) thick tile or like material can be cut
to size and t under lip of top trim edge for a decorative
touch. See Figure 15C.
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
Figure 15A
Figure 15B
Figure 15C
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGH T
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Decorative tile may
be installed