Filter
Top Products
Page 9SKU 93920
For technical questions, please call 1-800-444-3353.
Attach the Front-Center Top Stud (13) to the Front Crown Beams (2,3) using the
Top-center Connector (39) as shown below right.
Attach the Rear Crown Beams (4,5) to the Crown
(15b) in the same fashion as the Front Crown Beams
in step 2.
Attach a Corner End Cap (68) onto the outer end of
each Crown Beam (2-5). Cover the gaps between
the Crown Beams (between 2-3 & 4-5) with a Peak
Cap (72) in each. You may desire to use some silicone (not included) to secure
the Peak Caps (72) in place.
With two assistants, lift the Crown Assembly and place the Crown Beams (2-5) on
top of the Corner Brackets (26). (See Figure B.) Secure each corner in place with
the Crown Beams on the outside of the Corner Brackets.
Assembling the Studs and Braces
The 13 spots requiring a
Hold-down Connector
(44) are marked with
a plus (+).
Figure C
Note:
All Side Studs
(12) with no asterisk
are assembled using a
Long Bolt (60) for the bottom
connection.
All Side Studs (12) marked with an
asterisk (*) are assembled with one Long Bolt
(60) in the middle of the slot.
19
21
56
2
63
12*
12
12
12*
22
22
TOP
TOP
12*
12
12
12*
22
22
24
24
6
7
21
21
19
19
8
9
10
39
+
+
+
+
+
+
+
+
+
+
+
+
+
Attach the Rear-Left, Rear-Right, and Rear-Center Studs (8, 9, & 10) to the outside
of the Rear Floor Plate (16) and Rear Brace (23). Slide a Hold-Down Connector
5.
6.
7.
8.
1.
3913
2 3
3913
2 3