Filter
Top Products
Page 15SKU 93920
For technical questions, please call 1-800-444-3353.
Installing the Transparent Panels
Panel Clips (67) are used to secure the Transparent Panels in place on the Green-
house.
Remove the protective film from both sides of all panels.
20a/20b
48/50
48 48
15a/15b
35
36
50
The Roof Panels (48) and the Roof Window Panel (50) will need to be placed as
shown in the illustrations above. The top edges of these panels need to be placed
up under the edge of the Crown (15a, 15b) or the Window Support Beam (36).
One at a time, place each Transparent Panel (47 – 49, 51 – 55) in its proper location
on the Ceiling and Frame of the Greenhouse. Then, secure the Transparent Panel
in place, using the quantity and location of Panel Clips (67) as shown in the Panel
Installation Diagram, next page. Also, refer to the panel clip installation instructions
in the following step.
A
Transparent
Panel
Frame
Member
Panel
Clip (67)
B C
Be careful, Panel Clip (67) ends may be sharp and may spring back!
To attach Panel Clips:
Place the two loose ends of the Clip into the groove in the frame.
Swing the center portion of the Clip up against the panel.
Two edges of the Clip swing under the edge of the panel and the center edge
holds the panel in place.
1.
2.
3.
4.
5.
a.
b.
c.