Filter
Top Products
Operator's Manual Sixth Edition · Second Printing
28 Z-60/34 Part No. 1000209
OPERATING INSTRUCTIONS
Drive Enable
Light on indicates that the
primary boom has moved just
past either non-steer wheel and
the drive function has been
interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off
center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded
direction arrows on the platform
controls and drive chassis to
identify the direction the
machine will travel.
Drive Speed Select
· Machine on incline symbol: Low range
operation for inclines
· Machine on level surface symbol: High range
operation for maximum drive speed
Engine Idle Select (rpm)
Select engine idle (rpm) using the symbols on the
control panel.
When the foot switch is not pressed, the engine will
idle at its lowest rpm.
· Turtle symbol: foot switch activated low idle
· Rabbit symbol: foot switch activated high idle
Generator (if equipped)
To start the generator, move the generator toggle
switch to the on position.
Plug a power tool into the power to platform GFCI
outlet.
To turn off the generator, move the generator
toggle switch to the off position.
Note: Machine functions will not operate while the
generator is running and the foot switch is not
pressed down. When the foot switch is pressed
down, the generator will turn off and the machine
functions will operate.
Blue
Yellow