Filter
Top Products
Operator's Manual Sixth Edition · Second Printing
22 Z-60/34 Part No. 1000209
FUNCTION TESTS
Test Limited Drive Speed
44 Press down the foot switch.
45 Raise the primary boom approximately
2 feet / 61 cm.
46 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 1 foot / 30 cm per second.
47 Lower the primary boom to the stowed position.
48 Extend the primary boom approximately
2 feet / 61 cm.
49 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 foot / 30 cm per second.
50 Retract the primary boom to the stowed
position.
51 Raise the secondary boom approximately
2 feet / 61 cm.
52 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 foot / 30 cm per second.
53 Lower the secondary boom to the stowed
position.
Note: If the drive speed with the primary boom
raised or extended or the secondary boom raised
exceeds 1 foot / 30 cm per second, immediately
tag and remove the machine from service.
Test Auxiliary Controls
54 Shut the engine off.
55 Pull out the red Emergency Stop button to
the on position.
56 Press down the foot switch.
57 Simultaneously hold the auxiliary power switch
on and activate each function control handle or
toggle switch.
Note: To conserve battery power, test each
function through a partial cycle.
Result: All boom and steer functions should
operate. Drive functions should not operate with
auxiliary power.
Test the Lift/Drive Select Function
(if equipped)
58 Press down the foot switch.
59 Move the drive control handle off center and
activate a boom function toggle switch.
Result: No boom functions should operate. The
machine will move in the direction indicated on
the control panel.
60 Repair any malfunctions before operating the
machine.