Filter
Top Products
Set-up
14 OneWASH™ Power Washer
IMPORTANT: DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
Water supply must be adequate to handle greater than
3.8 gallons per minute and no less than 30 psi.
NOTE:
Using a One Way Valve (vacuum breaker or check
valve) at pump inlet can cause pump or inlet connec-
tor damage.
• There MUST be at least ten feet of unrestricted garden
hose between the power washer inlet and any device,
such as a vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow
this instruction will void warranty.
Figure 4-11. Inspect Inlet Screen
3. Connect the garden hose (not to exceed 50 feet in
length) to the water inlet (Figure 4-12). Tighten by
hand.
Figure 4-12. Connect Garden Hose
Risk of eye injury. Spray can splash back or
propel objects.
• Always wear safety goggles when using this equip-
ment or in vicinity of equipment in use.
• Before starting the power washer, be sure you are
wearing adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
4. Connect lance to spray gun (Figure 4-13). Tighten by
hand.
Figure 4-13. Attach Lance
5. Attach end of high pressure hose to base of spray
gun (Figure 4-14). Tighten by hand.
Figure 4-14. Connect Hose to Spray Gun
The high pressure stream of water that this
equipment produces can cut through skin and
its underlying tissues, leading to serious
injury and possible amputation.
• NEVER connect high pressure hose to lance.
• Keep high pressure hose connected to pump and
spray gun while system is pressurized.
• Always be certain spray gun, nozzles and accessories
are correctly attached.
A