Filter
Top Products
Generac Portable Products Power Transfer System
9
21. As shown in Figure 15, trim, strip, and connect
each wire to the appropriate terminal on the
locking receptacle on the connection box inner
panel. Use the schematic affixed to the inside of
the connection box to make proper wire
connections. When all connections have been
made, install the connection box inner panel.
Connecting Cord Set
22. Referring to the schematic in Figure 16 and the
markings on the connector itself, properly attach
the plug to the pigtail end of the connecting cord
set.
Identifying Circuits
A label, similar to that depicted in Figure 17, is
provided on each Load Manager switch cover. The
installer should fill in this information, describing the
appliance and the related circuit numbers in the load
control center.
This completes the installation of the Generac Portable
Products Power Transfer System. The installer should
test the system, as described in the TESTING section,
and instruct the homeowner in proper routine testing
techniques.
Figure 15 Connection Box Connections
Figure 16 50 Amp Cord Set Connector
Figure 17 Circuit Identification Label