Filter
Top Products
20
1.1 PURPOSE AND SCOPE
OF THE MANUAL
These Installation Instructions have been prepared especially for
the purpose of familiarizing installers and owners of the applicable
equipment with the product's installation requirements. Give seri-
ous consideration to all information and instructions in the manual,
both for safety and for continued reliable operation of the equip-
ment.
Because of the different recreational vehicle models and the
variations between the models, it would be extremely difficult, if
not impractical, to provide detailed instructions for every possible
installation. For that reason, instructions and illustrations in this
manual are general in nature. Illustrations are not intended to serve
as detailed installation blueprints.
The installation should comply strictly with all applicable codes,
standards and regulations pertaining to the installation and use of
this product. If any portion of this manual appears to be in conflict
with such codes, standards or regulations, the applicable codes,
standards or regulations must take precedence over the manual.
1.2 SAFETY
Before handling, installing, operating or servicing this equipment,
carefully read the “Notice to Installer” and “Safety Rules”. Comply
with all safety rules to prevent death, personal injury or damage to
equipment and/or property. Stress safety to all installers, operators
and service technicians who work on this equipment.
1.3 STANDARDS BOOKLETS
Installation, use and servicing of this equipment should comply
strictly with published standards, as well as the manufacturer's
recommendations. The following standards booklets (latest revi-
sion) are available from the sources indicated:
1. NFPA Standard 501C, “Standard for Recreational Vehicles,”
available from the National Fire Protection Association,
Batterymarch Park, Quincy, MA 02269.
2. NFPA 70, “NFPA Handbook of the National Electric Code,”
available same as Item 1.
3. ANSI C1-1975 and ANSI 119.2-1975, available from the
American National Standards Institute, 1430 Broadway, New
York, NY 10018.
4. ANSI A119.2/NFPA 501C, available from the Recreational
Vehicle Association, 1896 Preston White Drive, Reston, VA
22090.
5. California Administrative Code, Title 25, available from the
State of California, Documents Section, P.O. Box 1015, North
Highlands, CA 95660.
6. CSA Electrical Bulletin 946, available from the Canadian
Standards Association, Housing and Constructions Materials
Section, 178 Rexdale Boulevard, Rexdale, Ontario, Canada,
M9W 1R3.
1.4 EQUIPMENT DESCRIPTION
Instructions and information in this section pertain to air-cooled
generators. This generator is designed specifically for installing in
recreational vehicles. This generator operates 120-volts, single-
phase, 60-Hertz, AC electrical loads that require 30.0 amps.
1.5 GENERATOR ENGINE
OPERATING SPEED
The generator’s revolving field (rotor) is driven by a single-cylinder,
four-cycle engine. The generator supplies 120 volts AC at 60 Hertz
when the rotor is operating at 3,600 rpm.
1.6 GENERATOR AC
CONNECTION SYSTEM
The generator is equipped with dual stator power windings as
shown in Figure 1.1.
Figure 1.1 – 120-volt Single Voltage Connection
BLACK
The AC connection system on air-cooled generators uses a •
GROUNDED neutral.
A separate green ground wire is connected to the recreational •
vehicle’s junction box.
NOTE:
Do NOT connect loads in excess of circuit breaker ratings.
General Information