Filter
Top Products
48 - English
6. MENU FUNCTIONS
Test OUT
The Test OUT function is used to test if the selected
Guide width suits the installation in question and to
calculate the distance from the charging station to a
remote area.
To test the settings in Remote start 1:
Park the robotic lawnmower in the charging station
and select Test OUT - Remote start 1. The robotic
lawnmower will then leave the charging station straight
away along the guide wire and begin mowing after the
designated distance.
If there is a passage that the robotic lawnmower
cannot get through, the settings in Guide width ought
to be changed from Wide to Medium. If required, the
setting can also be changed to Narrow. The Narrow
guide width setting should only be used if none of the
other settings work for this installation. When the Test
OUT function is activated, the robotic lawnmower
travels the farthest distance from the wire allowed by
the selected guide width.
The figure here shows how the robotic lawnmower
travels through a passage when Guide width is set to
Medium and not to Wide.
How to measure the distance from the charging
station to a remote area:
Enter a distance which beyond any doubt exceeds the
real figure. The maximum distance that can be entered
is 500 metres. Park the robotic lawnmower in the
charging station and select Test OUT. The robotic
lawnmower will immediately leave the charging station.
The distance, stated in metres, will be shown in the
mower display as the robotic lawnmower operates.
Stop the robotic lawnmower at the required position
and note the distance. Enter the displayed number of
metres in the Distance field for the working area in
question.
If Remote start 2 has been activated, i.e. if another
option other than Never has been selected for
Proportion, these settings must also be tested. Remote
start 2 test is performed in the same way as for
Remote start 1.
Test IN
The Test IN function allows you to test how well the
robotic lawnmower docks with the charging station.
Test IN can only be performed after Test OUT has
been performed.
Selecting this function causes the robotic lawnmower
to travel directly along the guide wire towards the
charging station and to dock with it. The test is
approved only if the robotic lawnmower is able to dock
with the charging station at the first attempt. If the
robotic lawnmower is unable to dock on the first
attempt, it will automatically try again. The installation
is not approved if the robotic lawnmower needs two or
more attempts to dock with the charging station.
Remote start 1
Remote start 2
Test IN
Test OUT