Filter
Top Products
English - 47
6. MENU FUNCTIONS
Select the percentage that corresponds to the size
of the remote area relative to the total working
area. If the remote area is for instance less than
half of the total working area, then Rarely must be
selected. If the remote area is for instance half of
the total working area, Medium must be selected.
Compare with the examples in 7. Garden
examples on page54.
The default setting is Rarely.
• Distance
Enter the distance in metres along the guide wire
from the charging station to the remote area
where the robotic lawnmower begins mowing.
Tips! Use the Test OUT function to determine how
far it is to the remote area. The distance, stated in
metres, will be shown in the robotic lawnmower's
display.
Remote start 2
If the working area contains two remote areas, the
guide wire should be installed so that it reaches both
areas. Remote start 1 and Remote start 2 can then
be combined to steer the robotic lawnmower to each
area.
The settings for Proportion and Distance are carried
out in the same way as for Remote start 1.
The default setting is Never.
Take into account that the total figure for Proportion
cannot exceed 100%. If one has for instance selected
Often for Remote start 1, then one can only select
Never or Rarely for Remote start 2.
Guide width is the same for Remote start 1 and
Remote start 2. In this way, it is the narrowest passage
along the guide wire that limits the maximum guide
width.
Test settings
In the Test settings menu, it is possible to test the
settings for Remote start 1 and Remote start 2 and
that the selected Guide width works in the working
area in question.
Test IN
Test OUT
Guide width
Remote start 1
Remote start 2
Test settings
Drive past wire