Filter
Top Products
English - 29
3. INSTALLATION
Laying and connecting the guide wire
1. Run the wire through the slot in the bottom of the
charger plate.
2. Fit the connector to the guide wire in the same
way as for the boundary wire described in
3.5 Connecting the boundary wire on page 27.
Connect it to the contact pin on the charging
station that is labelled “Guide”.
3. Run the wire at least 2 metres straight out from
the front edge of the plate.
If the guide wire must be laid in a passage:
The robotic lawnmower follows the guide wire on
the same side of the wire to and from the
charging station. This means that the guide wire
is to the right of the robotic lawnmower when the
mower travels to the charging station while it is to
the left of the mower when the mower travels
away from the charging station.