Filter
Top Products
Lit. No. 94430/94431 15 April 1, 2005
MAINTENANCE
Drive Belt Replacement
Disconnect the electrical plug between the spreader and
truck before drive belt replacement.
1. Remove the motor cap assembly.
2. Loosen the four phillips head screws that fasten the
motor mount to the drive support.
3. Slide the motor toward the drive shaft.
4. Remove the belt and replace with a new one.
5. Slide the motor mount away from the drive shaft
until the proper tension of the drive belt is achieved.
After tightening the belt should easily deflect 3/8".
6. Tighten the four phillips head screws and replace
the motor cap.
Phillips Head Screws
Approx. 3/8”
Recycle
When your spreader has performed its useful life, the
majority of its components can be recycled as steel.
Gear oil shall be disposed of according to local
regulations. Balance of parts made of plastic shall be
disposed of in customary manner.
CAUTION
Overtightening the belt may result in damage
to the motor or bearings.