Filter
Top Products
April 1, 2005 10 Lit. No. 94430/94431
Spreader Control
There are two control options. They are the ON/OFF
Control and the Variable Speed (PWM) Control.
OPERATING THE SPREADER
ON/OFF Control (Early Style)
2
POWER
ON
OFF
15
RESET
1 (Emergency Stop)
Starting and Stopping the Motor
1. Move the power switch to the on position to start
the motor. Motor will start immediately. The power
switch will remain in this position. The power
switch works as emergency stop when required.
2. Move the power switch to the OFF position to stop
the motor. The power switch will remain in this
position.
NOTE: The truck ignition must be on to start the
spreader.
NOTE: If the truck ignition is turned off while the
spreader is running, the motor will stop.
If there are problems while operating the spreader, refer
to the Troubleshooting section in this manual.
NOTE: Always place the cover on the hopper to
prevent moisture buildup. Do not let the spreader
sit idle with material in the hopper for an extended
period of time. This can cause the material to
compact and reduce or stop the flow of material.
1. Power Switch - used to start and stop the spinner.
The power switch OFF position operates as
emergency stop when required.
2. Circuit Breaker - used to reset the control should an
electrical fault occur.
WARNING
Before starting the spreader, the driver shall
verify all bystanders are a minimum of 25 feet
away from operating spreader.
CAUTION
Do not swing spreader with material in the
hopper.
CAUTION
If the unit is equipped with a SWING AWAY
®
mount. Do not operate the spreader or the
vehicle without securing the hinge pin in the
base plate.