Filter
Top Products
Lit. No. 94430/94431 11 April 1, 2005
OPERATING THE SPREADER
ON/OFF Control (Late Style)
Starting the Motor
1. Set the power switch to the ON position to start the
motor. The motor will start immediately. The power
switch will remain in this position.
Blast Position
Move and hold the power switch to the BLAST position
for as long as momentary operation is needed. When
released, the switch will automatically return to the OFF
position and stop the motor.
Stopping the Motor
1. Set the power switch to the OFF position to stop the
motor. The power switch will remain in this position.
The power switch OFF position operates as
emergency stop when required.
NOTE: Always place the cover on the hopper to
prevent moisture buildup. Do not let the spreader
sit idle with material in the hopper for an extended
period of time. This can cause the material to
compact and reduce or stop the flow of material.
NOTE: The truck ignition must be on to start the
spreader.
NOTE: If the truck ignition is turned off while the
spreader is running, the motor will stop.
BLAST
ON
OFF
SPINNER
On/Off Control Switch
Used to start and stop
the spinner.
(Emergency Stop-OFF Position)
Spinner Indicator Light
Illuminated light Indicates
power to the motor.
WARNING
Before starting the spreader, the driver shall
verify all bystanders are a minimum of 25 feet
away from operating spreader.
CAUTION
Do not swing spreader with material in the
hopper.