Filter
Top Products
Lit. No. 94430/94431 13 April 1, 2005
REMOVING THE SPREADER
NOTE: Empty the hopper before removing the
spreader.
Removing the Fixed Mount Spreader
1. Unplug the spreader and stoplight (if equipped).
2. Remove the two 3/8" cap screws, washers, and
locknuts that fasten the spreader to the bumper of
the vehicle.
3. Use an additional person or clamps to support the
unit and then remove the four 3/8" cap screws and
locknuts that fasten the spreader to the top
brackets.
4. Remove the spreader from the vehicle and stand in
an upright position. This may require additional
support.
Removing the Fixed Mount Brackets
1. Remove the two 1/2" cap screws, washers and
locknuts that fasten the top bracket to the bed rail.
2. Remove the two 5/16" cap screws, washers and
locknuts that fasten the top brackets the side of the
bed rail.
3. Package the brackets with all hardware and store
with the unit.
NOTE: Empty the hopper before removing the
spreader.
Removing the Receiver Mount Spreader
1. Unplug the spreader.
2. Remove the pin from the receiver hitch.
3. Remove the spreader from the vehicle and stand in
an upright position. This may require additional
support.
NOTE: Empty the hopper before removing the
spreader.
Removing the SWING AWAY
®
Spreader
1. Unplug the spreader and stoplight (if equipped).
2. Remove the hitch pin from the latch side hinge pin.
3. Remove the 1/4" cap screw and locknut from the
hinged side hinge pin.
4. Use an additional person to support the unit and
remove both hinge pins.
5. Remove the spreader from the vehicle and stand in
an upright position. This may require additional
support.
Removing the SWING AWAY Top Brackets
1. Remove the two 1/2" cap screws, washers and
locknuts that fasten the top bracket to the bed rail.
2. Remove the two 5/16" cap screws and locknuts that
fasten the top bracket to the side of the bed rail.
3. Mark the location of any shims to aid in
reinstallation.
4. Package the brackets with all hardware and store
with the unit.
Removing the SWING AWAY Base Plates
1. Remove the three 3/8" cap screws, washers,
locknuts and any shims that fasten the base plate
to the bumper.
2. Mark the location of the shims to aid in
reinstallation.
3. Package the base plates with all hardware and
store with the unit.
CAUTION
During removal or mounting, securely grip
spreader to avoid dropping.