Filter
Top Products
Operation
Closing the Discharge Gate
For all Walk-Behind Units except Vantage: Push
down on the handle to close the gate.
Figure 18
1. Push down 2. Handle in gate closed
position
For Vantage Units: Push forward on the handle to
close the gate.
Figure 19
1. Push forward
2. Handle in gate closed
position
Removing the OCDWB01
1. Remove and retain the velcro straps that secure
the handle assembly cable to the mower. If
installed, remove and retain the loom clip from
the deck and replace the rear knob.
2. Remove the hairpin and clevis pin from the
handle assembly.
3. Remove the handle assembly:
• For all Walk-Behind Units except Vantage:
Slide the handle assembly upward and out of
the mounting bracket as shown in Figure 20.
Note: The mounting bracket does not have
to be removed from the front panel.
Figure 20
1. Clevis pin
3. Handle assembly
2. Hairpin 4. Mounting bracket
• For Vantage Units: Slide the handle
assembly rearward and out of the mounting
bracket as shown in Figure 20.
Note: The mounting bracket does not have
to be removed from the side panel.
14