Filter
Top Products
32
4.2.4 Adjust Throttle Lever Tension.
a) Stop engine, wait for all moving parts to stop, and remove key. Engage parking
brake.
b) Tension in throttle lever can be adjusted by adjusting the tightness of the lever
pivot bolt, which is located under the console. See Figure 12.
FIGURE 12
4.2.5 Electric Clutch Adjustment
:
No adjustment necessary.
4.2.6 Motion Control Lever Adjustment
:
NOTE: There are two lever height options available. Place the levers in the top two
holes to increase height of the levers, or in the bottom two holes to decrease the
height of the levers.
a) Align the levers front/rear position. With the levers in the neutral position,
loosen the hardware and adjust the levers sliding and/or tilting the lever(s)
forward or backward until properly aligned and tighten hardware (See Figure
13).
FIGURE 13
b) If the ends of the levers hit against each other, while in the drive position
(levers rotated in as far as possible), make adjustments by moving the levers
outwards to the neutral lock position and carefully bending them outward.
Move them back to the drive position and check for clearance. Repeat if
necessary.