Filter
Top Products
- 23 -
5.1.10 Check tire pressures:
Service Interval: 40 hrs.
a) Stop engine and remove key.
b) Inflate all four tires to 13 psi (90 kPa).
5.1.11 Check battery electrolyte level:
Service Interval: 40 hrs.
a) Stop engine and remove key.
b) Tilt seat up.
c) Remove vent caps from battery. Fill with water (distilled is recommended)
to bottom of vent wells and replace vent caps.
d) See Assembly Section 3.8, for servicing a new battery.
PART NO. 513747 LOCATION: Top Center of Console
Under Front of Seat
5.1.12 Check condition of belts:
Service Interval: 40 hrs.
a) Stop engine and remove key.
b) Check under engine deck to check pump drive belt.
c) Remove left and right belt shields on deck and lift up floor pan to inspect
deck drive belt.
d) See Sections 5.2.3 and 5.2.4, for belt adjustment.
5.1.13 Lubricate grease fittings:
Service Interval: Refer to chart.
a) Stop engine and remove key.
b) Lubricate fittings with one to two pumps of SAE No. 2 multi-purpose gun
grease.
Refer to the following chart for fitting locations and lubrication schedule.
LUBRICATION CHART
FITTING
LOCATIONS
INITIAL
PUMPS
NO. of
PLACES
SERVICE
INTERVAL
∗
1. Front Casters 2 2 40 hours
2. Front Caster Pivots 0 2
∗∗yearly
3. Height Adj. Shaft Brngs. 1 5 40 hours
4. Deck Drive Belt Idler Arm 1 1 40 hours
5. Brake Brackets 1 2 200 hours
6. Pump Drive Belt Idler Arm 1 1 40 hours
7. Deck Rear Struts 1 2 40 hours
∗
∗∗
∗
More often if operating under severe conditions.
∗∗
∗∗∗∗
∗∗
See 5.1.13 Section c) for special lubrication instructions.