Filter
Top Products
- 9 -
2.4.2 Charging Capacity: 15 amps
2.4.3 Battery Type: BCI Group U1
2.4.4 Battery Voltage: 12 Volt
2.4.5 Polarity: Negative Ground
2.4.6 Fuses: Two 20 amp blade type
2.4.7 Safety Interlock System: Operator must be in seat with
Blades disengaged
,
brake engaged
, and
motion control levers out
(neutral lock)
to start
engine
.
Operator must be in seat
when Blades are engaged
,
brake is disengaged
,
or
motion control
levers are moved in
or engine will stop.
Engine will stop if either the left, the right, or both levers are
moved from
neutral lock
position while brake is engaged
.
2.4.8 Tilt Switch: (Serial Nos. 220,000 & Higher) Shuts off the engine when the unit
is tilted more than 60° from horizontal.
2.5 OPERATOR CONTROLS
2.5.1 Steering and Motion Control:
Separate levers, on each side of the console, control speed and direction of
travel of the respective drive wheels.
Steering is controlled by varying the position of the levers relative to each
other.
Moving motion control levers outward
(in slots)
locks the drive system in
neutral.
2.5.2 Blade Engagement Switch: Engages electric clutch (to drive belt) which
engages mower blades.
2.5.3 Parking Brake Lever: Sets brakes.
2.5.4 Deck Height Adjustment Lever: Sets cutting height to desired position.
2.6 SEAT
2.6.1 Type: Standard seat: high back, foam padded (internal spring
suspension)with arm rests.
Optional suspension seat: high back, low profile foam-in-place cushion
(dampened, adjustable spring suspension) with armrests.
2.6.2 Mounting: Hinged to tilt up for access to hydraulic pumps, battery and other
components. Held in tilted position with prop rod. Adjustable fore and aft seat
track.
2.6.3 Armrests: Standard seat: foam padded flip-up armrests.
Optional suspension seat: molded adjustable flip-up armrests.
2.6.4 Seat Safety Switch: Incorporated into the Safety Interlock System.
Time delay seat switch eliminates rough ground cut-outs.
2.7 HYDROSTATIC GROUND DRIVE SYSTEM
2.7.1 Hydrostatic Pumps: Two Hydro Gear BDP-10L variable displacement piston
pumps.
2.7.2 Wheel Motors: Two Parker/Ross with 1 1/4” tapered shafts.
2.7.3 Hydraulic Oil Type: Synthetic Mobil 1 15W-50.
2.7.4 Hydraulic Oil Capacity: 2.1 qt.(2.0 L.)