Filter
Top Products
- 27 -
6.1.25 Mobil HTS grease (or food-grade antisieze) is used in the following locations:
a) Between the cutter housing spindle and bearings.
b) Between the cutter housing spindle and sheave.
c) Under top cutter housing bearing guard.
6.1.26 Dielectric grease is used on all blade type electrical connections to prevent
corrosion and loss of contact.
6.2 ADJUSTMENTS
IMPORTANT: Disengage PTO, shut off engine, wait for all moving parts to stop,
and remove key before servicing, cleaning or making any adjustments to the unit.
6.2.1 Cutting height and anti-scalp roller adjustment.
CAUTION
POTENTIAL HAZARD
♦ When mower deck is not installed or the two front
support rod hairpins are removed, the unbalanced
weight of the tractor or tractor with mounted mower
deck support frame may cause the front of the unit to
rise suddenly.
WHAT CAN HAPPEN
♦ If the unit rises suddenly, injury may occur.
HOW TO AVOID THE HAZARD
♦ Securely hold down the front end of the unit when the
mower deck is not installed or front support rod
hairpins are removed.
a) Stop engine and wait for all moving parts to stop.
b) Install hairpin clips in the holes for the desired cutting height (See Figure 9).
IMPORTANT: To maintain correct cutting height and rake, check the
following for proper adjustment.
1. The front and rear hairpins are in the same holes with the proper spacers
under the hair pins (See Figure 6).
2. The tire pressures are set as directed in Section 6.1.10.
3. The length of the rear deck support link assemblies should average
6.89” (approximately 6 7/8” (17.5 cm)) from the center of the balljoint to
the center of the farthest hole (See Figure 6).
NOTE: All (4) pins must equally support the weight of the deck.
Adjustment in the length of the rear deck support assemblies may be
necessary. If one side is longer than 6.89” (17.5 cm), than the opposite
side must be shorter by the same amount.