Filter
Top Products
46
47
7.66 Reassembly of Auger Assembly
NOTE: Before re-assembling, clean impeller
shaft where the auger pulley will be installed
using emery cloth, and lubricate shaft end with
anti-seize.
7.67 Replace Scraper Bar
NOTE: The Scraper Bar is reversible. Inspect
Scraper Bar on snowthrower before ordering a
replacement.
7.68 Gearbox Repair Information
Replace worn or damaged parts. Replace gas-
ket. Use 750369 grease. Torque self-tapping
screw to 15 Ft.Lbs. max.
3) With auger housing sitting on its back insert
gearbox / auger / impeller as an assembly
into place.
2) Check the end of the auger ight. Stamped
into the metal is an “L” on the left side or “R”
on the right as well as the auger width.
4) Reinstall screws to side of housing to
secure the auger bearings.
5) Turn Auger assembly over, put antiseize
compound on impeller shaft before installing
pulley. Torque at 15-20 Ft.Lbs.
6) Reinstall belt and reattach auger assembly
to powerhead. (Section 7.61 or 7.31).
1) Tip snowthrower so that Auger is down and
handles are up.
2) Remove the nuts and carriage bolts holding
the scraper to the housing.
3) The scraper bar is reversible and can be
turned over and reinstalled once before
replacement is required.
4) Reuse carriage bolts and nuts to install
scraper bar.
AUGER BEARING
RIGHT SIDE
AUGER
IMPELLER SHAFT
SCRAPER BAR
CARRIAGE BOLTS
AND NUTS
LEFT SIDE AUGER
30" AUGER WIDTH
1) Place auger bearings at ends of auger
with center notch in bearing toward housing
ends.
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com