Filter
Top Products
28
29
Section 7.11 Remove Console Panel to service
controls and handles.
1) Remove the four 5/16
"
screws that hold panel to
handle assembly. On re-assembly do not over
tighten.
2) Remove all of the knobs and the Headlight (
See Section 7.13 below).
3) Carefully separate lock tab at each side and
remove control panel from assembly.
4.) Reverse to reassemble. Check picture for
position of tabs and stops on back side of
Console Panel.
Section 7.13 Replace Headlight
Section 7.12 Auger Engagment Interlock
- When the auger and the traction engagement
levers are engaged at the same time, you can
remove your hand from the auger lever and the
auger will remain engaged as long as the traction
lever is also held down. This is to allow the
operator to adjust the discharge chute direction
without stopping. If problems occur with interlock,
check the spring and look for wear on the bracket.
You will see this on the right with the console panel
removed.
* Use two ngers to push up on Headlight Bezel to
release bottom tabs and remove Headlight.
* To remove harness connector, pull tabs on both
sides outward while pulling connector from
Headlight.
NOTE: Light is ‘on’ when engine is running. There
is not a switch. See engine manufacturers
manual for information on charging system.
INTERLOCK
SPRING
CHECK
WEAR
HERE
TABS
STOPS
LOCK TAB INTO HOLE
AUGER
ENGAGEMENT
LEVER
TRACTION
ENGAGEMENT
LEVER
SCREWS
CONSOLE
BACKSIDE VIEW
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com