Filter
Top Products
36
37
7.34 Replace Traction Drive Belt
1) Separate auger assembly from Powerhead
assembly (See section 7.61)
3) Use a 3/8
"
ratchet with 6" extension inserted
in square opening on the idler arm to
release the tension on the belt. Pull on
ratchet to rotate idler arm.
4) Remove defective belt and replace with new
traction drive belt.
NOTE: Idlers, Idler Brackets, and Springs
for both drive Belts are now accessable.
2) Ensure that idler spring is in place before
re-assembly. Put tape over the spring hook
on the outside of housing to keep the spring
in proper position.
5) Re-attach auger housing to powerhead (see
section 7.61 or section 7.32)
7.36 Idler Spring locations
7.33 Belt Guide Dimension.
AUGER BELT SPRING
TRACTION BELT SPRING
7.35 Replace Traction Drive Pulley
1) Separate powerhead assembly from auger
housing assembly (see section 7.61)
2) Remove Traction Drive Belt ( Section 7.33 )
from engine pulley.
3) Use traction drive belt to prevent drive
pulley from turning remove ” hex head
bolt holding the pulley in place
4) Use antiseize compound before replacing
Pulley and reinstall washer, bolt at 15-20
Ft.Lbs., and belt.
5) Reassemble auger housing to powerhead
assembly.
LEFT WHEEL
IDLER SPRING
DRIVE PLATE
SLOT
BELT GUIDE
1/16" to 1/8"
CLEARANCE
AUGER BELT
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com