Filter
Top Products
24
25
BELLCRANK SHIFTER
ADJUSTMENT
NUT and BOLT
SPEED CONTROL
ASSEMBLY
2nd Reverse
Position
6.23 Adjustment for Auger Control Rod
* The Auger Control Rod is on the handle at the
right side of the operator. Adjustment is required
if engagement is sluggish or if the auger does
not stop within 5 seconds of the release of the
auger engagement lever.
6.24 Adjustment for Speed Control Rod
* The Speed Control Rod is attached to the speed
selector at the right side of the operator console.
Adjustment is required when there are less than
two speed positions for reverse.
* Raise protective Spring Sleve to expose jam nut.
* Loosen the jam nut.
* Remove hairpin and disconnect control rod from
control lever.
* Turn the rod counter-clockwise to lengthen,
clockwise to shorten.
* Reconnect the control rod to the control lever.
The linkage should be slightly loose. If not
readjust, then tighten jam nut.
* Test auger disengagement. Stopping time must
be 5 seconds or less.
* If stopping is more than 5 seconds, readjust rod
for more slack. Remove belt cover and check to
see if idler arm will move freely by engaging auger
control lever. Retest stopping time.
* Loosen the nut and bolt at the middle of the rod.
* Hold Bellcrank Shifter (p 35 key 33) in maximum
counterclockwise position with one hand, and
tighten the nut and bolt with other hand.
* Speed Control in last notch ( 2nd reverse position)
PROTECTIVE
SLEEVE
JAM NUT
CONTROL ROD
LEVER
CONTROL
ROD
RETAINER
SPRING
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com