Filter
Top Products
18
CS-352
Open choke
Choke control knob
Chain brake
RUNNING
• When engine starts, keep idling for a few minutes.
• Set the brake lever in the unlocked position before
starting to cut.
• Pull throttle trigger gradually and increase revolution
of the engine.
• The chain starts running when the engine reaches
4,200 r/min approximately.
• Conrm proper acceleration and lubrication of chain
and bar. (Non-adjustable automatic oil pump)
• Do not run the engine at high speed unnecessarily.
• Be sure that saw chain stops moving when throttle
trigger is released.
STOPPING
• Release throttle trigger and move ignition switch down
to “STOP” position.
NOTICE
If engine does not stop, pull choke control knob out
fully to stop engine.
Return the unit to your authorized ECHO dealer
to check and repair stop switch before starting the
engine again.
STOP
Ignition switch
Throttle trigger
Unlock chain brake
WHEN THE ENGINE IS WARM
CAUTION
Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Move chain brake lever fully forward to lock chain
brake before starting.
• Conrm there is fuel and chain oil in the tanks.
• Move ignition switch to “RUN” position.
• Securely hold the chain saw as shown and pull
starter handle.
• Choke may be used if necessary, but after rst ring
sound, pull throttle trigger to release choke.
NOTE
Ifenginedoesnotstartafter5pulls,repeatinstruc-
tions.