Filter
Top Products
12
CS-352
PREPARATION FOR USE
Bolt (A)
Dimple (D)
Recess (E)
Front hole (C)
Rear hole (B)
Nut (F)
Guide bar
Kick Guard
®
WARNING
Saw chain is sharp! Always wear gloves when
handling assembly, otherwise serious personal
injury may result.
KICK GUARD
®
TO BAR INSTRUC-
TIONS
1. Install bolt (A) in rear hole (B) of Kick Guard
®
and
through front hole (C) in guide bar.
2. IMPORTANT: Dimple (D) in Kick Guard
®
must en-
gage recess (E) in guide bar.
3. Tighten nut (F) and bolt (A) using 11 mm (7/16 in.)
wrenches until snug. Make certain Kick Guard
®
is
ush against guide bar.
4. Tighten nut (F) 1/8 additional turn.
5. Check to make certain Kick Guard
®
is tight on guide
bar.
GUIDE BAR AND SAW CHAIN IN-
STALLATION/REMOVAL
1. Remove spark plug lead. (See page 25)
2. Remove two clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See “Main-
tenance and Care” section for guide bar/saw chain
maintenance procedures.
Clutch cover
Brake lever
(Front hand guard)
Two nuts
Unlock chain brake
WARNING
Using improper replacement components or remov-
ing safety devices may result in serious or fatal
injury.