Echo X750020201 Chainsaw User Manual


  Open as PDF
of 40
 
17
CS-352
Start / Run
Ignition switch
Chain brake
Starter handle
Choke
Choke control knob
Purge pump
WHEN THE ENGINE IS COLD
CAUTION
Make sure the bar and chain are free from any
obstruction when starting the chain saw.
• Movechainbrakeleverfullyforwardtolockchain
brakebeforestarting.
• Fillthefueltankwithfuelmixture.
Itisnotpermittedtollfuelabovetheshoulderlevel
offueltank.
• Fillthechainoiltankwithlubricant.
Donotoverll.
• Moveignitionswitchto“RUN”position.
• Pushpurgepump3to4timesoruntilfuelisvisiblein
purge pump.
• Pullchokecontrolknoballthewayout.(Chokeposi-
tion)
NOTE
Donotpullstarterropeouttothemaximumpossible
position.
Donotallowrecoilhandletosnapbackagainstthe
casing.
• Securelyholdthechainsawasshownandpullstarter
handleseveraltimesuntilrstringsound.
• Pushchokecontrolknoballthewayin.
• Pullstarterhandletostarttheengine.
• Whenenginestarts,immediatelysqueezethrottletrig-
ger,toreleasethrottlelatch.
Start / Run
Ignition switch
Chain brake
Starter handle
Choke
Choke control knob
Purge pump
WARNING
• After choke control knob is pulled and then knob
is returned to original position, throttle remains
slightly open (latch condition).
•The chain will attempt to rotate when
engine is started with throttle latch engaged.
•Do not start engine before chain brake is
activated.
CAUTION
• After starting the engine, squeeze throttle trigger
slightly to release throttle latch, otherwise brake
damage may occur.
• Never use throttle latch for cutting.
• Use the throttle latch only in starting.
CAUTION
Donotincreaseenginespeedwhilechainbrakeis
locked.
NOTE
Ifenginedoesnotstartafter5pulls,repeatinstruc-
tions.
 previous next