Dynasty Spas 2006 Hot Tub User Manual


 
- 5 -
1) READ AND FOLLOW ALL INSTRUCTIONS.
2) WARNING: To reduce the risk of injury, do not permit children to
use this product unless they are closely supervised at all times.
Keep spa cover locked when not in use.
3) Wiring should be done by a qualified electrician, according to the
directions listed under “Set-up And Delivery Guidelines”, and
“Wiring Diagram”. A GFCI must be used.
4) DANGER: Risk of injury. The suction fittings in this spa are sized to
match the specific water flow created by the pump, be sure that
the flow rates are compatible. Never operate the spa if the suction
fittings are broken or missing. Never replace a suction fitting with
one rated less that the flow rate marked on the original suction
fitting.
5) DANGER: Risk of electrical shock. Install at least 5 feet (1.5m)
from all metal surfaces. As an alternative, a spa may be installed
within 5 feet of metal surfaces if each metal surface is permanently
connected by a minimum #8 AWG solid copper conductor to the
wire connector on the terminal box that is provided for this
purpose.
6) DANGER: Risk of electrical shock. Do not permit any electrical
appliance, such as light, telephone, radio or television within 5ft.
(1.5m) of spa.
7) WARNING: To reduce the risk of injury:
The water temperature in a spa should never exceed 104°F. A
water temperature of 104°F is considered safe for a healthy adult.
Lower water temperatures are recommended for young children
and when spa use exceeds 10 minutes.
Since excessive water temperatures have a high potential for
causing fetal injury during the early months of pregnancy, pregnant
or possibly pregnant women should consult their physician before
use.
Before entering a spa, the user should measure the water
temperature with an accurate thermometer since the tolerance of
water temperature regulating devices varies.
The use of alcohol or medications before or during spa use may
lead to unconsciousness with the possibility of drowning.
Important Safety Instructions
When installing and using this electrical equipment, basic safety
precautions should be followed, including the following: