Filter
Top Products
- 18 -
Keeping Your Spa Water Clean & Fresh
(An Overview)
Monthly - For Equipment Protection
CALCIUM BOOSTER (If Needed) - Calcium booster treats the
water if low calcium hardness is a problem in your area. It will help
prevent equipment corrosion and foaming by raising the spa's
water hardness level to an acceptable range of 120 ppm.
Filter Cleaning
To keep your filter free of grease, grime, and oil. Clean the filter
with SPA CARTRIDGE FILTER CLEAN. One 16 oz. bottle treats a
55 square foot filter. See Filter Maintenance section for location
and diagram.
As Needed
Surface Cleaning
Between refills and as needed, clean the surface using SPA
MULTI-PURPOSE CLEANER. For tough scale & stains, use
STAIN & SCALE REMOVER.
Surface Protection
To protect and seal the spa surface, use SPA FAST GLOSS every
time you drain and clean the spa.
Water Balance
Adjust the pH quickly and easily with pH STABILIZER. It will
properly adjust and hold the pH for up to 3 months. Note: Not
recommended for calcium hardness levels above 200 ppm. Use
SPA UP to raise pH and SPA DOWN to lower pH.
Sanitizing
Use 2 ounces of SODIUM BROMIDE to create a bromide reserve.
When using BROMINATING TABLETS in a floating basket, two to
three tablets will treat up to 500 gallons of water. For a chlorine
system, use CHLORINATING GRANULES (1/2 oz. per 500
gallons).