Filter
Top Products
23
MACHINE USE
QUICK OPERATIONS CHECKLIST
Before using the saw each time, verify the following:
1, The blade is tight.
2. The bevel angle and height lock-knobs are tight.
3. If ripping, ensure that the fence lock lever is tight and that the fence is parallel to the blade.
4. If crosscutting, ensure that the miter gauge knob is tight.
5. Proper eye, hearing, and respiratory equipment are being used.
6. The blade guard is properly attached and the anti-kickback pawls are functioning.
Failure to adhere to these common safety rules can greatly increase the likelihood of injury.
KEY PARTS AND SAFETY FEATURES ON YOUR SAW
FRONT VIEW
1. Extension Wing
2. Miter Gauge Lock
3. Miter Gauge
4. Miter Gauge Slot
5. Table Top
6. Blade Guard/Splitter/Anti-
Kickback Pawl Assembly
7. Miter Gauge Slot
8. Rip Fence
9. Extension Wing
10. Extension Table
11. Rip Fence Lock
12. Tilt Angle Scale
13. Elevation Handwheel Lock-knob
14. Elevation Handwheel
15. Tilt Angle Indicator
16. Tilt Handwheel
17. ON/OFF Switch
18. Tilt Handwheel Lock-Knob
1
62 3 4
5
7 8 9 10
11
12
13
14
15
16
17
18
Common sawing operations include ripping and cross cutting plus a few other standard operations. As with all power machines,
a certain amount of hazard is involved with the operation and use of the machine. Using the machine with the respect and
caution will considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or
completely ignored, personal injury can result. The following information describes the safe and proper method for performing
the most common sawing operations.
This instruction manual does not provide information regarding the installation of a fence system. A
fence system must be installed before use of the saw. Please refer to the fence instruction manual regarding the proper
installation, alignment, and operation of the fence system.
The use of attachments and accessories not recommended be Delta may result in injury.
Never operate the saw without the proper table insert for the saw blade or cutter installed.