Filter
Top Products
11
OPERATION
Reverse: The snow thrower has two reverse (R) speeds—R1 is the
slower of the two.
Choke Control
The choke control is found on the top of the engine and is
activated by rotating the knob counter clockwise. Activating
the choke control closes the choke plate on the carburetor
and aids in starting the engine.
Primer
Depressing the primer forces fuel directly into the engine’s carburetor
to aid in cold-weather starting.
Oil Fill
Engine oil level can be checked and oil added through the oil fill.
Safety Key
The safety key must be pushed in place in order for the engine to start.
Pull the safety key out to prevent unauthorized use of equipment.
Rocker Switch
The rocker switch is used to stop the engine. The switch must be in
the “ON” position in order to start the engine.
Figure 12
WARNING: Read, understand, and follow all
instructions and warnings on the machine and in
this manual before operating.
Now that you have set up your snow thrower for operation, get
acquainted with its controls and features. These are described below
and illustrated on this page. This knowledge will allow you to use your
new equipment to its fullest potential.
NOTE: For detailed starting instructions and more
information on all engine controls, refer to the separate
engine manual packed with your unit.
Shift Lever
The shift lever is located in the center of the handle
panel and is used to determine ground speed and
direction of travel. It can be moved into any of eight
positions.
IMPORTANT: Always release drive control before
changing speeds.
Forward: The snow thrower has six forward (F)
speeds. Position one (1) is the slowest and position six
(6) is the fastest.
Engine Controls
Recoil Starter
Handle
Choke
Control
Electric Starter
Outlet
(optional)
Electric Start
Button
(optional)
Primer
Safety
Key
Rocker
Switch
Oil Fill
Gas Cap
Chute Assembly
Clean-Out Tool
Drive Control
Two-Way Chute Control
Auger Control
Wheel Steering
Control
Skid Shoe
Chute
Directional
Control
Shift Lever
Headlight
Augers